Two new boats in this update. The first is a 16' version of the 27' whaler. I needed a 16' lifeboat for my tugboat and scaling the 27' whaler on all axis didn't look right. So I just scaled the length and left the width and height the same. The second boat is a USN 40' Motor Boat. It's an enclosed boat used for officer transport, presumably since the officers didn't want to get wet. It prints without support, since the file includes a removable support for the overhang in the back of the boat. I printed it with 20% infill and 2 perimeters. For the first 10mm I used 0.25mm layers and 0.1mm layers above that to make the top look better, especially the hand rails.
Some basic lifeboats 1.3
3 different lifeboats, from 36' to 27' with a 1900's era steam launch
-
New 40' Motor Boat and 16' whaler
