IJN Utility Boats 1.0

rcengr · Feb 14, 2017

rcengr submitted a new resource:

IJN Utility Boats - At set of three different Japanese WWII boats

This is a set of three IJN utility boats. There is an 11m motor boat (top), a 12m covered motor launch (center), and a 9m cutter (right).

These boats have pads at the bow and stern to prevent them from lifting during printing. The pads are actually separate shells, so you can remove them in the slicer if you don't want to use them. In Slic3r, select "split" and it will break the .stl into 3 pieces. Then delete the pads and print the boats with a brim or setting of your choice. The pads...
Click to expand...

Read more about this resource...

Log in or Sign up

IJN Utility Boats 1.0

rcengr Vendor