Prinz Eugen build (IRWCC)

Greetings all,
Finally got to work on my Prinz Eugen special thanks to @modelshipsahoy for a beautiful hull and kit. After 3 cups of coffee and a trip to autozone for some pin stripping she is coming along I will update as the day goes on. I’m hoping to get some cutting done by this evening but we will see

 

Finally got to work on her and only one side done

 

Another day off and I got the cutting done Almost ready to start the water sealing once the hardware kit arrives

 

FYI, the stringer width/height is limited to 1/8," looks closer to 1/4" in the picture so I recommend shaving it down a bit

 

I’m going to shave it down when I clean up the edges of the windows while I wait for the rest of the drive system to get here

 

All right guys I know it’s been a while since I’ve added to this post but time to update everybody and show this lovely lady (paint job was done by my wife so she gets all the credit)

 

Looks like it just came back from a swim. Is that supposed to be island camouflage?

 

it’s more of a cross between that and if she rose from the depths to sail again(kinda like the Flying Dutchman from Pirates of the Caribbean)